Well pump repair in Aiken, SC
No water at the tap, pressure that comes and goes, or a pump that won't shut off. Call and get a well technician working on it.
Signs your well system needs attention
- No water anywhere in the house, or water that sputters and spits air
- Pressure that drops off in the shower, then comes back
- The pump clicks on and off every few seconds (short cycling)
- Your power bill jumped and the pump seems to run constantly
- Cloudy, sandy, or rusty water that showed up suddenly
- Trouble started right after a summer thunderstorm
What usually goes wrong
Most "the well is dead" calls turn out to be something above ground. A failed pressure switch, a waterlogged pressure tank, a tripped breaker, or a burned control box can all stop water completely. These are often fixed in one visit without pulling the pump.
When the problem is down in the well, a technician will check the pump motor, the wiring, and the drop pipe. Lightning is a common cause of pump failure in South Carolina, so if your water stopped during a storm, mention it when you call.
Pressure tank problems
The pressure tank is what keeps your pump from turning on every time you open a faucet. When its air charge is lost, the pump short cycles, which wears it out early. Recharging or replacing the tank is a much smaller job than replacing a pump, and catching it early can add years to the pump's life.
What to do before the technician arrives
- Check the breaker for the well pump and reset it once. If it trips again, leave it off.
- Look at the pressure gauge near the tank and note the reading.
- Don't keep flipping the pump on and off. That can burn out the motor.
Areas served
Well pump repair for homes in Aiken and across Aiken County.
Other services
Out of water or dealing with a backup?
Call now and describe what's going on. It's the fastest way to get someone scheduled.
Call (803) 620-9675